Process Essay - How to Wash and Polish a Car -- essays research papers

Process Essay - How to Wash and Polish a Car You should only wash your car with 100% Cotton towels (white only) that are made in the U.S.A. Only these towels will not scratch or leave swirl marks on your paint. The knap in the cotton will absorb a fair amount of dirt and keep it from coming in contact with your paint. When drying your car you should use 100% Cotton towels (white only) that are made in the U.S.A. or the Absorber. The absorber is made from Surgical Silicone and will not leave swirl marks on your car. However, the Absorber will not absorb dirt or particles like the towels. Therefore, you have to pay special close attention not to pick up any dirt with it. You could drag the particles along and swirl/scratch your car up some. I use the absorber and have not had any problems so far. I wash every painted surface on my car as well. What should I use to protect my car's paint finish? We use the Zaino Car Polish system on our car. Nothing else comes close to matching Zaino's unbeatable protection, shine and ease of use. Visit Zaino's website and read over all of it. What should you do before you apply that FIRST coat of Zaino? 1. Wash your car (using the 100% White Made in the U.S.A. Cotton towels) with Dawn dish washing liquid or equivalent. You want to get rid of any wax, polish, dirt, grease or grim off your car. 2. Don't dry your car off! That would be a waste of time in this case. 3. Get a Clay Bar from (Pep Boys (must be blue if you buy it from Pep Boys) or Zaino Z-18 Clay Bar). Place about 1-2 cap fulls of your favorite car wash in a spray bottle and fill it up with water. Shake and spray until you get the soapy water coming out. This step is optional but HIGHLY recommended! Start on a small section of your car. Spray the carwash water mixture in the spray bottle on the car and pull the clay bar across your paint. What?! Yeah, don't apply any pressure just pull it across. It should slide like a hockey puck on ice. Again, place no pressure on the bar, let the bar do the work for you. 3a. Have a bug stain? Just re clay until the stain comes off. You will need to knead your clay bar to keep the dirt and contaminants off the surface of the clay bar your are touching the car with. Same goes for tar spots or over spray from the factory! This stuff is great! 4. Do this to your whole car. Take your time!!! and make sure you keep the surface you ... ...ld do. You should let this dry to a haze before applying your next coat. Z1 usually dries by the time you finish putting it on your car. Grab another cotton applicator and I recommend starting with a coat of Z5 next. The same goes for Z5, dab a little on the applicator (or paint) and go for it. Start in the same spot you started with Z1. Once you finish your car, simply let it dry. How long is long enough? When you can swipe your finger through the polish applying very little (almost no pressure) pressure to the paint and the polish comes clean off and shines, then it is dry. Usually takes between 15 minutes and 2 hours. This depends on the temp and how thin you spread it. The more practice you get the less time to dry. I would let it set for a good 2 hours before touching it if this is your first time. Once Z1 and Z5 have dried, simply take a White 100% Cotton towel that is Made in the U.S.A. and wipe off the polish. Remember to turn the towel frequently so it comes in contact with dry sides of the towel. If your polish is not dry and you attempt to take it off, don't worry. You are essentially just pushing the polish around on the car. Give it some more time and then try again.